The Scratch-B-Gone kit for Stainless steel is the recognized leader in helping the do-it-yourselfer repair any 'real' brushed surface of Stainless steel. Take you time and watch the enclosed video in the kit and you should be successful. Thanks for asking, Barry Feinman, inventor. Barry Feinman. The chemistry which is used to strip the CrN or chromium is as follows: Take step 1) 1 lit of DI water heat up to 50 °C. Then take step 2) 15 gms of KMnO4 and 40 gms of KOH. mix step 2) in step 1) then insert the tools which has to be stripped. Heat the solution up to 90 ° C. Here your stripping time will take 4-5 hrs. Tiny spots or streaks of rust can appear on the stainless steel finish of your appliances, marring its smooth, silvery surface, not to mention its premium looks. Don't fret. Rust is treatable. And Let it sit and then wipe the oil out. After that, proceed to wash with dish soap and hot water. Other recommendations are to gently scrub using a mixture of lemon juice and salt and then wash. Some SS cookware comes with instructions to scrub it gently with a 1:1 mix of baking soda and warm water before using the pans. Get as much as you can off with your fingers. Get some acetone (or at least acetone-based nail polish remover), dab some on a paper towel, and rub it into the taped area, letting it soak into it. After giving it a minute, try rubbing more off with your fingers. Alternate applications of acetone and rubbing it off. Many people have had good results with Bar Keeper's Friend, a powdered cleaner safe for stainless steel. Another method is using a rubbing compound, such as those made by 3M. Again, be sure to rub in the direction of the grain. A piece of wet fine-grit sandpaper can also be used to remove deeper scratches. Always keep it wet, and follow up with lHF1. Suspend parts in a Dicro-Clean 909 cleaning solution to remove dirt, grease, oil, and debris. Mix the Dicro-Clean 909 Solution with 1 gallon of water at a rate of 5 ounces (by weight of Dicro-Clean). Heat the 909 Solution to 180° F. before immersing the pieces for 10 to 15 minutes. FIPA creates gripper system for protective film removal for sheet metal handling. FIPA Inc. recently created a custom EOAT solution that facilitates the removal of protective film from sheet metal with a cost- and labor-saving automated process. Developed for Foilpuller GmbH, a stainless steel sheet metal processing company based in Bobingen A cloth. Steps to Remove the Residue: Put a hair dryer on the warm setting and point it at the residue, holding it several inches away. Hold the hair dryer in place for a minute or two. Wet a cloth with hot water (not so hot you get burned!). Rub off the residue, always going with the grain of the stainless steel. Comment. Splash a little white vinegar diluted with water into your pan, swirl the mixture around, and use a non-abrasive sponge to wipe away the rainbow stains. Vinegar's acidity will help break down that thin oxidized rainbow layer while still being gentle on your pans. (Alternatively, a sprinkle of Bar Keepers Friend, which is similarly Heat is the safest way. Apply for a few seconds (or minute, then pull until it's not easy to pull. Repeat. Use gloves if too hot. Chemicals and application products, such as certain cloths, can damage stainless steel and/or other metals. You could heavily damage the finish, even if you are safe.

how to remove old protective film from stainless steel